Cookies on this website

We use cookies to ensure that we give you the best experience on our website. If you click 'Accept all cookies' we'll assume that you are happy to receive all cookies and you won't see this message again. If you click 'Reject all non-essential cookies' only necessary cookies providing core functionality such as security, network management, and accessibility will be enabled. Click 'Find out more' for information on how to change your cookie settings.

Two piezocones, with cross-sectional areas of 1 cm2and 5 cm2and a variety of pore pressure filters, were driven at the standard rate 20 mm/s into models of thinly layered soil, and pore pressure dissipation tests were also performed. The models consisted of alternating layers of pre-consolidated kaolin clay and more permeable layers of silt or fine sand, enclosed in a 400 mm diameter cell with either a rigid or a flexible lateral boundary. Control tests were performed on a clay model without any sand or silt layers. The experiments demonstrate the feasibility of using miniature piezocones to detect individual permeable layers as thin as 2 mm in normally and lightly overconsolidated clay deposits, provided their vertical spacing is at least two cone diameters and a sufficiently fast data recording rate is used. However, the lateral extent of a permeable layer cannot be gauged from a single piezocone probe. Pore pressure dissipation tests in clay layers are not significantly affected by neighbouring permeable layers provided they are more than two cone diameters above or below the filter element. On the basis of the experimental results, it is suggested that miniature piezocones could be used to improve the investigation of thinly layered ground, as might be found in alluvial and estuarine areas.

Original publication

DOI

10.1680/geot.2003.53.10.885

Type

Journal article

Journal

Geotechnique

Publication Date

01/01/2003

Volume

53

Pages

885 - 900